Cascadia installs, replaces, and completes selected repairs on residential fences in Bothell. The estimate starts with the proposed line, grade, gate access, nearby driveways and corners, and the best available property information. Board direction and material come after those questions.
The Bothell service-area overview covers both deck and fence work, and the Bothell deck builder page handles deck projects. This page focuses on the fence decision and what the Bothell Municipal Code publishes for fences.
Bothell uses one height threshold, not two
Many nearby cities cut the allowed fence height inside the front yard. Bothell does not publish a separate front-yard maximum in the municipal code. Bothell Municipal Code 12.14.150 states that where no landscape buffer is required, fences and freestanding walls six feet or less in nominal height may be allowed without a setback within any front, rear, or side yard.
The permit threshold matches that number. BMC 20.02.095 exempts fences not over six feet high from a building permit, so a fence over six feet requires one. A fence that exceeds a nominal height of six feet must also comply with the required front, side, and rear yard setbacks, and a fence six feet or less may project into any setback.
Treat this as the code text, not as a guarantee for a specific parcel. Landscape buffer requirements under Chapter 12.18 BMC come first, since a fence must be placed behind any required buffer.
How Bothell measures the height
The code measures fence height from the horizontal projection of the predominant ground level, using either the city-approved finish grade where one has been established or the predominant existing grade in the vicinity of the fence. Height is measured to the upper surface of the fence or freestanding wall panel.
That wording matters on a sloping run, because the reference is a predominant ground level rather than a point-by-point measurement. Photograph the entire route from both ends and show the high and low sides so the top line can be planned before posts are set.
Sight distance and hydrant clearance
Bothell requires that all fences and freestanding walls comply with the sight distance requirements of the Bothell Standards. The municipal code itself does not restate those dimensions, so the applicable triangle at a corner or driveway is determined from the city engineering standards and by the city.
The code does publish one clearance number directly. No fence or freestanding wall may be placed closer than three feet to, or obscure the vision of, any fire hydrant.
Send photos of the driveway approach, the corner, and any hydrant along the route so those constraints are handled in the layout rather than after installation.
Retaining walls and guards
Where the residential or building code requires a guard on top of a retaining wall or retaining structure, any fence or freestanding wall in that location must meet the minimum guard height and construction requirements of that code. A fence on a wall is a structural question, not only an appearance one.
Bothell exempts retaining walls not over four feet, measured from the bottom of the footing to the top of the wall, unless they support a surcharge. Chapter 12.14.152 BMC limits outward-facing retaining structures to a maximum of four feet in front and rear yards and six feet in side yards, with setback, separation, and facing-material requirements above certain heights.
The code does not publish a single combined fence plus wall height cap. Where a wall runs along the fence line, expect the city to review the assembly as a whole.
Critical areas and prohibited fence types
Bothell requires buildings and other structures to be set back 15 feet from the edges of all critical area buffers, or from the edges of critical areas where no buffer is required, with listed features allowed inside that setback. Landslide and erosion hazard areas, stream riparian management zones, and wetland buffers are defined in Chapter 14.04 BMC and can change what is possible along a property edge.
Electric fences are permitted in residential zones only for agricultural or pasturing purposes, with permanent warning signs of at least two square feet every 50 feet and at least six feet of clearance from fire hydrants. Barbed wire is limited to animal husbandry and security uses with chief of police approval. Razor wire is prohibited except for military and police security installations.
Plan the gate before the adjoining panels
A gate needs enough width for its real use, a workable swing direction, latch clearance, supported posts, and room above changing grade. Daily access for bins, pets, and equipment can point to a different opening than occasional wider access.
The posts beside a gate carry repeated movement, so their placement belongs in the fence plan. The gate and selected fence repair guide explains when a dragging gate reflects post movement rather than hardware.
A Cascadia fence example
The project image on this page is Cascadia work. Its location is not published, and it is not presented as a Bothell installation. The related cedar privacy fence collection can support a conversation about screening, board direction, and top lines beside landscaping.
The example shows the service. It does not establish a Bothell address, permit history, customer, price, product specification, or completion date.
What to send for a Bothell fence estimate
- The address or ZIP code and what the fence needs to do
- Wide photos of the full line, both ends, corners, and every grade change
- Photos of the driveway approach, the street corner, and any fire hydrant
- Intended height, board direction, post preference, and gate locations and widths
- Photos of retaining walls, rockeries, raised beds, and landscape buffers along the route
- Any available survey, plat, easement, critical-area record, or earlier permit record
- Whether the scope includes removal, disposal, selected repair, or full replacement
Bothell fence questions
Is my front-yard fence limited to a lower height in Bothell?
The municipal code does not publish a separate front-yard fence maximum. It allows fences six feet or less without a setback in any front, rear, or side yard where no landscape buffer is required. Confirm buffer requirements and the specific parcel with the city before relying on that.
When does a Bothell fence need a permit?
Bothell exempts fences not over six feet high from a building permit. A fence over six feet requires one and must also meet the required yard setbacks.
What about the corner of my lot?
The code requires compliance with the sight distance requirements of the Bothell Standards and does not restate the numbers. The applicable triangle is determined by the city.
Can Cascadia remove the old fence?
Yes. Fence replacement is within Cascadia’s approved services. The estimate should identify the sections removed, debris handling, access, and any part that remains.
Cascadia Deck & Fence LLC is a Washington contractor, registration CASCADF741LJ, and is licensed, bonded, and insured. Free estimates are available. Workmanship warranty options up to four years are available with select packages and must be documented in the written agreement.
Read the regional permit research guide, then request a free Bothell fence estimate with photos of the full line, grade, and gates.
